How to use the morphological parsers
Setting up the environment (You probably did this already):
Analysing and generating words
- Analysis, write u and the 3-letter language code using the (basic) xfst program, e.g. for North Saami, write usme, and <ENTER>. Then write the words that shall be analysed, one word at a time, followed by <ENTER>. To leave analysis mode, press ctrl C.
- For generation, use d instead of u, e.g. dsme. Then write lemma and grammatical tags (in the same form as was given as output, followed by <ENTER>.
- For testing, you may also write a file with one wordform on each line, and then feed that to the analyser (example here is for Inari Saami, with a file testfile.txt):
cat testfile.txt | usmn | less
If you want to use hfst instead of xfst, write husme and hdsme. The actual command behind these aliases are revealed by writing alias usme etc. If this commands gives no answer, you should run command sh gtsetup.sh. See the documentation in the preamble.
Text analysis (xfst)
We have set up aliases for text analysis (xfst only), the aliases contain a pipeline combining perl pre- and postprocessing with xfst transducers and constraint grammar. These aliases may be written anywhere (replace "sme" with your own language code).
- Gives a sentence analysis of North Saami
- Gives a dependency analysis of North Saami
- Gives a sentence analysis of North Saami, in trace mode (showing which dis rules work)
- Gives a dependency analysis of North Saami, in trace mode (showing which dep rules work)
These aliases may be used in two ways: either write the alias followed by a sentence in quotes
smedis "Mun lean boahtán."
Or, alternatively, pipe a file through it:
cat testfile.txt | smedis
Text analysis (hfst)
For hfst, we have an alternative procedure for preprocessing text, using transducers instead of perl. The command to tokenise, analyse and print the output in a CG compatible format is:
cat testfile.txt | hfst-tokenise --giella-cg tools/tokenisers/tokeniser-disamb-gt-desc.pmhfst
In case the transducer contains weights, the constraint grammar may make use of them, as follows
cat text | hfst-tokenise --giella-cg tools/tokenisers/tokeniser-disamb-gt-desc.pmhfst | ...
Please note that the file tools/tokenisers/tokeniser-disamb-gt-desc.pmhfst is not built by default. To enable building it, configure as follows:
./configure --with-hfst --enable-tokenisers
This setup is experimental, so there are no aliases yet
(Warning: this part contains basic unix commands only.)
Instead of just showing the result on the screen as running text (as above), much can be done to manipulate it. Here are some examples, all the textstrings should be added after the smedis etc. above.
| grep '+N+Pl' > plnouns
(to get all plural nouns and save them to the file plnouns)
| grep -v '\?' | cut -f2 | sort | uniq -c | sort -nr | less
(to get a frequency list of the lexemes that the parser recognizes.
| grep '\?' | sort | uniq -c | sort -nr | less
(to get a frequency list of the words that the parser does not recognize)
| grep '\+\?' | sort | uniq -c | sort -nr | less
(to get a frequency list of the word forms that the parser does not recognize)
Last modified $Date: 2017-10-03 22:27:21 +0200 (tir, 03 okt 2017) $, by $Author: trond $
by Trond Trosterud